Good Earth Lighting SE1249-WH3-02LF7-G Manual Del Usuario página 2

OPTION 1: WALL MOUNT
OPTION 2: EAVE MOUNT
WARNING!
SHUT OFF POWER BEFORE REMOVING OR INSTALLING ANY FIXTURE.
The fixture can be mounted to a round surface mount or a recessed electrical box.
from the wall plate.
Before installing, measure the distance between the holes on the junction box to match that
distance with the holes on the wall plate of the light.
For surface mount: Use only with an approve UL wet location surface electrical box.
The wall plate is fashioned with 2 sets of mounting holes with different distances apart. Before
attaching the wall plate to the fixture, determine which set of mounting holes corresponds to the
electrical box.
Remove the knockouts at these locations by carefully hammering a screwdriver, punch or nail until they
break free.
Feed the fixture wires through wall plate and thread the wall plate onto the mounting arm.
DD
x3
Fixture must be properly grounded. Using the provided wire nuts (DD), connect fixture ground wire to ground wire. These wires can be either green or bare copper.
Connect black supply lead with the black fixture wires and white supply lead with the white fixture wires using the wire nuts (DD). Secure the wire nuts properly to
prevent the wires from coming loose. Push connections and excess wires back into the compartment.
Determine which machine screws ((BB) or (CC)) fit the threaded holes in the j-box. Insert them through the mounting holes in the wall plate and in the threaded holes in
the j-box and tighten. Tighten the machine screws (CC) until snug with the included Allen wrench (EE).
Use silicone adhesive caulking (not included) to seal the gap between the wall plate and the mounting surface to prevent water seepage into the j-box.
PREPARATION
INSTALLATION
Determine which
knock-outs need
to be removed
NOTE: If the holes do not match up with the holes in
the junction box, loosen the base by turning the collar
ring toward the wall plate until snug.
CCx2
or
EEx1
BBx2
Align the "-" marks on the elbow
joint and pivot joint.
Tighten both star knobs.
NOTE: The PIR sensor and light
head must be mounted with the
control panel facing toward the
ground to prevent water from
damaging the fixture. Failure to
do so will void the warranty.
Align the "=" marks on the elbow
joint and pivot joint.
Tighten both star knobs.
NOTE: The PIR sensor and light
head must be mounted with the
control panel facing toward the
ground to prevent water from
damaging the fixture. Failure to
do so will void the warranty.
ROUND SURFACE
MOUNT ELECTRICAL BOXES
NOTE: for round surface mount
electrical box, remove the liner from
the foam gasket (AA) and stick to
edge of the round surface box.
Pull the wires through.
Make sure the gasket (AA) properly seals the gap
between the wall plate and electrical box to prevent
water from seeping into the j-box.(Proceed to Step 1)
2