Good Earth Lighting SE1249-WH3-02LF7-G Manual Del Usuario página 3

THE CONTROL PANEL (LOCATED ON THE UNDER SIDE OF THE SENSOR) MUST FACE DOWN TOWARD
THE GROUND AT ALL TIMES TO PREVENT WATER FROM ENTERING AND DAMAGING THE UNIT.
SENSOR ORIENTATION
The sensor can be tilted up and down. Adjust the
sensor to preferred angle.
BRIGHTNESS AND COLOR TEMPERATURE OPERATIONS
SELECTING BRIGHTNESS
By pressing this button, select either "High Beam"
(7000 lumens) or "Low Beam" (2000 lumens).
NOTE: The default setting is "High Beam" (7000 lumens).
THE FIXTURE CANNOT BE USED AS A DUSK-TO-DAWN LIGHT. THE FIXTURE HAS A BUILT-IN LIGHT
SENSOR THAT PREVENTS THE MOTION SENSOR FROM ACTIVATING DURING DAYLIGHT HOURS.
When the MINUTES control is set to MOTION
TEST, the light will operate both during
daylight and night time.
The greater the DISTANCE setting, the great the
chance for false activations by the (PIR) sensor.
LIGHT AND PIR SENSOR ORIENTATION
LIGHT ORIENTATION
USING THE LIGHT ACTIVATION CONTROLS
MOTION TEST MODE TO SET DISTANCE
Rotate the MINUTES control knob to MOTION TEST to calibrate the
fixture. The light will turn on for approximately 20 seconds.
Allow the motion sensor about 2 minutes to warm up prior to
conducting the "walk by test".
With the control knob set to MOTION TEST, do a "Walk by Test"
by walking in front of the motion sensor (figure at right).
As movement is detected, the light will activate. Remain still
for approximately 5 seconds (when movement is no longer
detected), the light will shut off. Resume walking and the light should
turn on. Once out of the detection range, the light will shut off and
the test is complete.
SET MINUTES KNOB TO
Motion Test
SETTING THE LIGHT DURATION TIME
Rotate the MINUTES control knob away from the MOTION TEST and set between the 1 and 10. Do not rotate the
MINUTES control knob back to the TEST area, or to switch control.
SET MINUTES KNOB TO
Anywhere from 1 to 10
SETTING THE MOTION DETECTION DISTANCE
Rotate the DISTANCE control knob anywhere from "10Ft" to MAX. (100 ft)
When the DISTANCE control knob is turned to "10Ft", the detection zone
is very tight and compact, causing the detection sensitivity to be very high.
The reverse is true, when the DISTANCE control knob is turned to "MAX."
it increases the detection zone exponentially. Perform a "walk by test" by
walking across the motion detection field at the approximate distance set
on the DISTANCE control knob.
SET MINUTES KNOB TO
Anywhere from 1 to 10
To adjust the angle of the
light, loosen the two knobs
on the back of the light and
position the light as
preferred (up and down, or
left and right). Once in
position, tighten both knobs
to lock the light into place.
NOTE: The default setting is Daylight (5000°K).
SELECTING WHITE LIGHT
By pressing this button, select from Warm White (3000°K), Bright
White (4000°K) or Daylight (5000°K).
SET DISTANCE KNOB TO
Any distance
SET DISTANCE KNOB TO
Any distance
SET DISTANCE KNOB TO
10Ft to MAX (100 ft.)
180°
SET WALL SWITCH TO
ON
SET WALL SWITCH TO
ON
180°
SET WALL SWITCH TO
3
ON