Mainfunction; Installation - Lacor 69065 Manual Del Usuario

7.- Unit is not weatherproof. For safe and proper operation locate
the unit indoors where the ambient air temperature is a
minimum of 70ºF (21ºC) and a maximum of 85ºF (29ºC).
8.- Do not locate the toaster in an area subject to excessive
temperature or grease from grills, fryers, etc. Excessive
temperature could cause damage to the unit.
9.- Do not place toaster in an area that restrict air flow around the
front or rear of the unit.
10.- Some exterior surfaces on the unit will get hot. Use caution
when touching these areas toavoid injury.
For toasting slices of bread or pastries which do not contain butter, jam or any other product that
might liquefy when heated, as these could drip onto the heating element and burn, causing
unpleasant odours.
UNPACKING
1.- Open the box and remove all the packaging materials, the device's protective cover and its
accessories.
2.- Remove all accessories and book instructions.
3.- Please make sure that you clean all parts that come into contact with food with soapy water,
and then dry.
TOAST FEED RAMP
The toast feed ramp is installed at the factory and can be used in two positions.
1.- When in the upright position, the toaster is set for automatic feed. Bread products enter the
toaster by placing them on the feed ramp and releasing.
2.- For manual feeding of product, tip the feed ramp until it rests on top of the unit. In this
position bread products can be manually loaded by placing them directly on the conveyor
belt.
TOAST CRUMB TRAY
Install toast crumb tray directly below the conveyor belt. Insert until the front of the crumb tray
meets the stop pins.
MAIN FUNCTION

INSTALLATION

35