Installation - Lacor BUFFET DUAL Manual Del Usuario

Open the large box. Remove all packing materials and protective covering from the unit and parts.
Do not discard the wrapping until you have checked that the blender is working correctly.
This item comes partially unassembled. Carefully read the following points regarding its

installation:

1.- Before beginning assembly, remove the grey protective film from all the surfaces.
2.- Make sure the packaging includes everything stated (Figure 1).
3.- RScrew the item's 4 feet into the underneath of the base. Adjust the feet so that
the item remains level on the surface on which it will be operating (Figure 2).
4.- Use 4 long screws (M5 x 35) to fit the right vertical support to the base.
The power cable coming from the base must remain inside this support.
The connector must protrude through the top of the support.
Tighten the screws using the key included in the packaging so that the support holds secure
(Figure 2).
5.- Use 4 long screws (M5 x 35) to fit the left vertical support to the base. Tighten the screws using
the key included in the packaging, so that the support holds secure (Figure 3).
6.- Insert the connector from the upper lighting support into the connector that is protruding from
the top of the right vertical support (Figure 4).
7.- Place the upper horizontal support onto the vertical supports. Take care with the
cable and the connectors, these must remain inside the supports.
8.- Screw 3 short screws (M5 x 16) into each side of the upper horizontal support in order to fix it
to the vertical supports. Tighten the screws using the key included in the packaging (Figure 5).
9.- Fit the bulbs into the light fittings, screwing them in a clockwise direction. Ensure the bulbs
being fitted are of the wattage stated in the Main Technical Specifications section (Figure 5).
1
1
1.- 3x60x22 (1)
2.- M5x16 (6)
3.- M5x35 (8)
4.- Ø45xM8 (4)
32
INSTALLATION
2
2
3
4
4
3
5