Screw Lock Type Crown - Seiko 7D46 Manual De Instrucciones

SCREW LOCK TYPE CROWN

●
Some models have the screw lock type crown, which can be locked by the screw
when it is not necessary to be operated.
●
Locking the crown will prevent operating errors.
●
Unscrew the crown before any crown operation. When the operation is over,
screw the crown in to lock.
■ HOW TO OPERATE THE SCREW LOCK TYPE CROWN
If your watch has a screw lock type crown, unscrew it before any crown operation.
❖ Always keep the crown locked unless it is necessary for operating the crown.
[To unscrew the crown]
Turn the crown counterclockwise (down-
ward) to unscrew it. The crown is unlocked
and can be operated.
[To screw the crown in]
Upon completion of the crown operation,
screw the crown in completely until it stops
by turning it clockwise (upward) while gen-
tly pressing it back into the original position.
10
All manuals and user guides at all-guides.com
The crown can be pulled out.
Turn the crown while pressing
it back in.
HOW TO WAKE UP THE WATCH FROM POWER SAVE MODE
●
In order to "wake up" the watch from power save mode, swing the watch gently
from side to side to recharge it.
✽
Do not pull out the crown to the second click position before performing the following
procedures. This will cancel the time relay function.
Swing the watch from side to side approximately 4 to 6 times rhythmically at
a rate of twice a second, making an arc of about 20 cm as shown in the
illustration below.
✽
No additional benefit is obtained by swinging the watch with
greater vigor.
✽
When the watch is swung, the oscillating weight in the generating
system rotates to drive the mechanism. As it rotates, it gives out
a sound, which is not a malfunction.
1. Only the hour, minute and 24-
hour hands move quickly to indi-
cate the current time which has
been internally retained in the
built-in IC.
The second hand
remains still.
2. Then the second hand will follow
quickly to resume the normal
movement.
11