Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
•
Put the top rails together so they form a circle.
•
With the top rail frame connected into a circle, lay it flat on the floor (either side facing up-they are
identical). Then insert the tapered end of each of the 6 leg tubes into the 6 leg sockets that are fac-
ing up, as shown.
•
Align the screw hole in the leg with the hole in the leg socket. Then secure with secure and tighten.
DO NOT OVER-TIGHTEN. Repeat this until all 6 legs are securely attached to the top rail frame with
screws.
•
After attaching all 6 of the legs securely to the top rail frame, turn the frame over so that the legs
point downward, as shown.
•
To ensure that the enclosure mesh conectors will be properly aligned with the enclosure poles, hold
up the mesh by one of the nylon patches with grommet and select the nylon loop sewn onto the
jump mat that is directly beneath the nylon patch you are holding. The patch at the top, the upper
and lower hook & loop fasteners, and the nylon loop on the mat will all be along the same line(sewn
to the mat) will be the first one you attach, and MUST be attached to the frame right next to one of
the 6 enclosure pole sockets.
11
All manuals and user guides at all-guides.com
Assembly
Publicidad
Tabla de contenido
