Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
•
Insert the smaller diameter end of an upper enclosure pole into the larger diameter end of a lower
enclosure pole and align screw holes.(You may need to slide the preinstalled foam sleeves to gain
access to the ends of the pole)
•
Insert screw& tighten. DO NOT OVER-TIGHTEN. Repeat steps 1&2 to assemble remaining 5 sets of
upper &lower poles.
•
Insert the bottom end of enclosure pole assembly into the socket on frame, as shown. Align screw
holes.
•
Insert screw & tighten. DO NOT OVER-TIGHTEN. Repeat steps 3 with the remaining 5 enclosure pole
assemblies.
•
Locate the 6 nylon patches with grommets that are sewn onto the top edge of the mesh. Select a
nylon patch that aligns with a pole. Carefully slip one of the patches over the top of the enclosure
pole so that the grommet is aligned with the screw hole in the pole .Use care so that you do not tear
the mesh.
•
Insert screw & tighten. DO NOT OVER-TIGHTEN. Repeat steps 5 with the remaining 5 patches and
poles. When done properly, the enclosure mesh will be hanging on the INSIDE of the enclosure poles.
The mesh should hang down somewhat straight and not ' twist'
•
Locate the upper and lower sets of hook and loop fasteners sewn to the enclosure mesh , there are
6 upper and 6 lower set of hook &loop fasteners.
•
Tightly wrap both the upper &lower hook and loop fasteners around the enclosure pole foam to secure
the mesh in place , repeat this with the remaining upper and lower hook & loop fasteners on the other
5 enclosure poles.
13
All manuals and user guides at all-guides.com
Manufacturer
Chal-Tec GmbH, Wallstraße 16, 10179 Berlin, Germany
Publicidad
Tabla de contenido
