YATO YT-82230 Manual De Instrucciones página 10

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 50
CHARACTERISTICS OF TOOL
Orbital sander is an ordinary tool, of the class II isolation, designed mainly for finishing of wood and to a lesser extent for sanding
metal surfaces, especially in the corners and places difficult to access. Grinding is done with a paper, which is commonly avail-
able in trade, or with an abrasive cloth, in the form of properly shaped surfaces. In any case, you should not use the tools for the
machining of materials other than those listed above, for example. for grinding plaster, fillers with fiber reinforcement, etc. Correct,
reliable, and safe operation of the device is dependent on its proper use, therefore:
Prior to working with the tool, you should read all the instruction and keep it around.
Attention! The dust generated during grinding of certain surfaces can be harmful for health, and even toxic.
This note applies to i.a. grinding the surfaces coated with paints containing lead, to some species of wood, some metals (e.g.
lead) and materials, therefore, during the work you should use an effective dust extraction, dust masks and other measures to
protect the skin and respiratory tract. For any damage caused by failure to comply with safety regulations and instructions of this
manual, the supplier is not responsible.
EQUIPMENT
The sander is supplied complete, with one sheet of sandpaper and connector for dust discharge..
TECHNICAL PARAMETERS
Parameter
Type
Mains voltage
Mains frequency
Rated power
Number of oscillations
Dimensions of the foot
Dimensions of the abrasive sheet
Weight
Noise level
- accustic pressure LpA ± KpA
- accustic power LwA ± KwA
Vibrations a
± K
h
Insulation class
Degree of protection
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fire or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain inflammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fire in case of contact with inflammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fit the mains socket. Do not modify the plug. Do not use any adapters whatso-
ever in order to adapt the plug to the socket. Unmodified plug which fits the socket reduces the risk of an electric shock.
Avoid contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk
of an electric shock.
Do not expose electric tools to precipitation or humidity. Water and humidity which gets into the electric tool increases the
risk of an electric shock.
Do not overload the power supply cable. Do not use the power supply cable in order to carry the tool or to connect and
disconnect the plug from the mains socket. Avoid contact of the power supply cable with heat, oils, sharp tools and
O R I G I N A L
10
All manuals and user guides at all-guides.com
GB
Unit
[V]
[Hz]
[W]
[min
-1
]
[mm]
[mm]
[kg]
[dB(A)]
[dB(A)]
[m/s
]
2
I N S T R U C T I O N S
Value
YT-82230
230 AC
50
260
13,000
187 x 90
238 x 90
1.8
82.0 ± 3.0
93.0 ± 3.0
5.4 ± 1.5
II
IP20

Publicidad

Tabla de contenido
loading

Tabla de contenido