Filling The Water Tank Or Emptying The Compartment When Cleaning; Suction And Scrubbing Modes; Specify The Area For Cleaning; Programmed Cleaning - SPC BAAMBA GYRO PRO SUCTION 4400 Manual De Instrucciones

EN

3.11 FILLING THE WATER TANK OR EMPTYING THE COMPARTMENT WHEN CLEANING

If you need to fill the water tank or empty the compartment because it is full while the robot is
working, press button to stop it; remove the water tank and refill, or remove the compartment
and empty it; then put them back and press button again to continue cleaning.

3.12 SUCTION AND SCRUBBING MODES

You can select 4 suction modes from the SPC IoT application, Normal, Eco, Low and Pro, with Eco
selected by default.
You can also modify the amount of water used when scrubbing, choosing from the 3 modes offered
by the robot, Eco, Normal and Pro.

3.13 SPECIFY THE AREA FOR CLEANING

You can create virtual walls with magnetic tape to prevent the robot from entering certain areas. Just
put the tape on the floor, and the robot will not pass over it.

3.14 PROGRAMMED CLEANING

You can establish a weekly cleaning schedule with the SPC IoT application. The robot will start
cleaning at the set time and return to the charging base when it has finished cleaning.
You can also programme a daily cleaning routine from the remote control. You cannot choose the
days of the week so the robot will start at the set time every day. First set the time on the remote by
pressing button and select the correct time with the arrows; then press button and select
the time, once selected press the same button again pointing at the robot, the icon will appear on
the remote control display and the robot will emit a sound.
To remove a programme on the remote control, keep the button pressed for around 5 seconds,
the robot will beep and the icon will disappear from the screen.

3.15 INDICATOR LIGHTS

If the Wi-Fi indicator flashes green, it means that the robot is in synchronization mode.
If the Wi-Fi indicator flashes slowly in green, it means that the robot is in AP synchronization mode.
If the Wi-Fi indicator is green, it means that the robot is correctly connected to the network.
If the Wi-Fi indicator is off, it means that the robot cannot connect to the network.
If the button is green, it means that the robot is working correctly.
If the button is flashing orange, it means that the robot is charging.
If the button is orange, it means that the robot is returning to the charging base.
If the button is flashing red, it means there is a problem with the cleaning, probably a blockage.

3.16 CONFIGURING THE NETWORK AND UPDATING THE FIRMWARE

To reset the network configuration, press the button for around 5 seconds or use the SPC IoT
application (follow the steps in the quick guide to connect the robot to the application) to delete the
device; bear in mind that it is not compatible with 5Ghz networks.
If the robot is connected to your Wi-Fi network, you can control it remotely with your smartphone.
To update the firmware, use the SPC IoT application, make sure that the battery is not below 60%.