Peltor Lite-Com Pro Guia De Inicio Rapido página 6

Note: For maximum ambient-noise compensation, position the microphone on the headset no less than
3–5 mm from the lips.
SQUELCH (hiss reduction)
Squelch means that the noise in the earphones is reduced when the incoming signal is below a set level.
This way, the user doesn't have to listen to background hiss. When someone speaks, the amplification
returns instantly to the proper level. Use the
message confirms the new setting each time you press the button. There are five SQUELCH levels
and an off mode. Level 1 is most sensitive, renewing amplification at the lowest input signal. To access
off mode, press and hold the
confirms "
Squelch off
SUB CHANNEL (Selective reception)
When a radio receiver has selective reception, a certain tone or code must be transmitted along with the
speech in order to be received. This allows multiple groups of users to use the same channel without
interfering with each other.
Use the (+) and
up down
each time you press the button. There are 38 analogue CTCSS tones and 8 digital DCS codes. They
are programmed with numbers 1–121 (see table F on the inside cover). If the function is switched to
OFF, all communication on the channel can be monitored.
POWER (output)
There are three output power levels: High, medium and low. Use the
select the output power level. A voice message confirms the new setting each time you press the button.
We recommend using
Note:
The battery life/operating time depends to a great extent on the type and condition of the batteries
and how the Lite-Com Pro is used. For example, with an alkaline battery with at least 2700 mAh, the
operating time in low-power mode is about 40 hours at 15% transmission and 85% reception/stand-by.
In high-power mode, the operating time under the same conditions decreases by about 20%. With 20%
transmission and 80% reception/stand-by, the operating time is about 35 hours at medium power. TA
BORT
PTT (Push-to-talk)
Press PTT to transmit manually using the Lite-Com Pro radio.
Notes:
. Switch voice control (VOX) on and off by pressing the button briefly twice. A voice message, "VOX
on" or "VOX off" confirms the setting.
. The Lite-Com Pro has busy channel lockout (BCLO) to block transmissions on busy channels.
ASSEMBLY/CONFIGURATION
BATTERIES
Note: When using the Lite-Com in environments with a risk for explosions, ATEX-approved batteries
are required! Never change batteries or charge accumulators in an explosive environment!
Only the following types of batteries are currently approved for use in the Peltor Lite-Com Pro in
explosive environments:
Manufacturer
Peltor
Duracell
Energizer
4
All manuals and user guides at all-guides.com
up
(–) button for two seconds in volume step one. A voice message
down
". To switch VOX on again, press the
(–) buttons to set the subchannel. A voice message confirms the new setting
where possible.
medium power
Battery type:
ACK05
MN1500, Procell PC1500
E91, Industrial EN91
(+) and (–) buttons to set the squelch level. A voice
down
(+) button.
up
(+) and
up
(–) buttons to
down