Bosch NEB 36 Manual De Instrucciones página 7

3) Prepare the Countertop
4) Secure Cooktop to Countertop
All manuals and user guides at all-guides.com
4. Remove excess tape where tape ends butt.
Swivel Conduit Connector
The cutout dimensions depend upon whether the installation is for replacement,
new construction, or installation in a solid surface countertop material, such as
Surel™, Corian® etc. Countertops made from natural (i.e. granite and marble) or
SOLID SURFACE MATERIALS, such as Surell™ and Corian® require larger cut-
outs, use of heat reflective tape and rounded corners. Always consult the counter-
top manufacturer for specific instructions.
For Standard Countertops
1. Cut out the countertop according to the dimensions shown in Table 1.
For Solid Surface Countertops
1. Use the maximum cutout dimensions in Table 1 and consult the countertop
surface manufacturer for specific cutting instructions.
2. Round the cutout corners per instructions from countertop manufacturer.
3. Apply heat reflective tape (such as Scotch® Aluminum Foil Tape #425 or
#427) around the cutout so that it folds over the top and side surfaces. Be
sure the tape extends beyond the outermost flange of the cooktop. All corners
should also be covered with tape.
Applying Heat Reflective Tape for Solid Surface Installation
Figure 5:
The cooktop should be secured to countertop using hold-down brackets provided.
1. Turn cooktop upside down and attach the brackets to the burner box using the
washers and screws. Use the unthreaded screw holes for attaching the
bracket to the cooktop. The threaded screw holes are needed for the clamp-
ing screws that attach the bracket to the countertop in a later step.
2. Rotate the mounting brackets sideways to allow enough clearance for the
cooktop to be inserted through the cutout opening.
3. Place cooktop into cutout. Center cooktop in the cutout to ensure adequate
clearance between the burner box and countertop edge. (A light pencil mark
along the center of front edge and side edge of cooktop and counter will aid in
the positioning of the cooktop in the center.)
Foam
Tape
Seal
Start tape in middle
of a side, not on a corner
Seal the Cooktop
Figure 4:
shows location of
aluminum reflective
tape
tape top and vertical
sides of cutout
English 5