Bosch NEB 36 Manual De Instrucciones página 8

5) Trim Excess Aluminum Tape
(solid surface countertop
installation only)
6) Electrical Connection
7) Final Check
English 6
All manuals and user guides at all-guides.com
4. Place a wood block on the underside of the cabinet where the adjusting screw
will meet the countertop. The adjusting screws will tighten down on the wood
block to clamp the cooktop tightly to the countertop. This will protect the coun-
tertop surface from damage.
burner box
washer
screw
clamping screw
5. Rotate brackets into proper position and insert clamping screws into the
brackets.
6. Tighten clamping screws into wood blocks to secure cooktop to countertop.
Trim excess aluminum tape from along the frame edges. BE CAREFUL not to
scratch the countertop.
1. Attach flexible conduit to the junction box.
2. Connect the cooktop lead wires to the junction box supply wires in proper
phase: for all models, connect black (L1) to black, red (L2) to red, white wire
to neutral, green wire to ground.
Note: The ground wire and neutral wire are twisted together at the factory. For
proper operation, untwist and connect to the required four wire system.
NOTE: If the cooktop is installed and connected as specified above, it will be com-
pletely grounded in compliance with the National Electrical Code.
1. Remove everything from the cooktop surface and apply glass ceramic cook-
top cleaner (packaged with cooktop) as directed in Use and Care Manual.
2. Turn on power supply.
3. Test operation.
CAUTION
to the Use and Care Manual before using it for the first time.
bracket
wood block
threaded
screw hole
: Your cooktop surface needs to be cleaned daily. Refer
countertop
burner box
bracket
Secure the Cooktop
Figure 6: