Safety Instruction - Rothenberger 5.6271 Instrucciones De Uso

Safety instruction

For tapping, use ROTHENBERGER high-performance thread-tapping oil art. no. 6.5010. This oil
is not suitable for tapping drinking water pipes!
Alternatively, you can use ROTHENBERGER high-performance thread-tapping fluid, art. no.
6.5015. This fluid is suitable for tapping all pipelines (including drinking water pipelines).
Precise thread-tapping is only possible if the number on the slot of the thread-tapping head
corresponds with the number on the thread jaw!
Use only raw material that is in perfect condition for tapping threads.
If you use deformed and / or pipes cut off at an angle, it is not possible to tap threads that
conform to the relevant standards!
Use the thread-tapping head and the corresponding thread-tapping jaws that matches the
thread size! Secure the thread-tapping head correctly on the tool carriage.
Do not place the thread-tapping head directly and unprotected on the floor and handle it with
care!
Ensure that the thread-tapping oil runs on the thread-tapping jaws!
Apply anti-rust grease if the machine is not going to be used for an extended period!
Overview
1
T-handle
2
Selector pin (silver)
3 Selector pin (black)
4 Threaded pin (fast adjustment)
5
Profile body
Installing the thread jaws from and in the thread-tapping head
Wear gloves in order to prevent cut injuries to the hands caused by the
thread jaws!
Pull the parking lever in the "A" direction in order to open the thread jaws.
Insert the selector pin (silver colour) into the selector block of the thread jaws.
Insert the thread jaws with the same number as on the respective thread-tapping head and
make sure it engages audibly.
Ensure that the numbers on the thread-tapping head and on the thread jaws are on the
same side.
Changing the thread size
Insert the selector pin into the selector block with the necessary thread size.
The size is shown on the respective selector block.
Use the silver selector pin and the block for ½" ... 1" and the black selector pins for 1 ¼"...
2".
Lower the thread-tapping head and insert the T handle, pressing in fully in the "B"
direction until the thread-tapping jaws engage in the working position
4
All manuals and user guides at all-guides.com
6
Profile pin
7
Locking lever, body
8 Locking lever, clamping head
9 Cam plate
10
Selector block
ENGLISH
A
B
C