Publicidad
Timer
1
5
4
4
10
9
Buttons
and LED indicators
1
Select operating state (clockwise):
2
Continuous
3
Setting mode
4
Operation via time switch
5
Permanent stop
6
Time
7
LED ring of the runtimes (see fig. 2, page 23)
8
Select times (time and runtimes)
9
Pump running (LED lights up) or is off
(LED does not light up)
10
Confirm time/confirm or delete runtimes
All manuals and user guides at all-guides.com
1
2
3
6
7
8
:
When it is connected to the electricity mains for the first
„
time, the pump runs continuously (delivered condition –
LEDs
and
light up,
9
3
Shortest runtime is 30 minutes.
„
When the power supply is interrupted, the time stops
„
(no power reserve). The saved runtimes
If the power supply is restored, the pump runs in the
operating state that was last set,
has to be updated.
Setting the time and runtimes:
►
Press
until
lights up.
1
3
►
Use
to set the red LED to the current time and confirm
8
with OK
.
no longer lights up. The green LED in the
10
9
section 0.00 h to 0.30 h flashes.
►
With
, set the LED to the required runtime and confirm
8
with OK
. The LED jumps directly to the next runtime.
10
Confirm once again with OK
LED ring runs more quickly if
►
End setting with
. The saved runtimes are displayed.
1
The pump runs according to the set runtimes,
up.
flashes (see figure 1).
6
are retained.
7
flashes. The time
6
or skip with
(etc.). The
10
8
is held down.
8
lights
4
22
Publicidad
