Waeco PerfectView CAM26W Instrucciones De Montaje Y De Servicio página 40

_RV-HD-STANDARD.book Seite 40 Montag, 28. November 2005 3:46 15
Safety and installation instructions
Observe the following installation instructions:
Secure the parts of the rear view system installed in the vehicle in such a way
that they cannot become loose under any circumstances (sudden braking,
accidents) and cause injury to the occupants of the vehicle.
Secure any parts of the system covered by the bodywork in such a
manner that they cannot become loose or damage other parts and
cables and impair vehicle functions (steering, pedals, etc).
Do not attach the monitor in the area that may be used by an airbag,
as this could cause injury if the airbags are triggered.
To prevent damage, when drilling ensure that there is sufficient room for
the drill head to come out on the other side (2, page 4).
Deburr all drill holes and treat them with a rust-protection agent.
Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.)
may only be performed by qualified specialists.
Observe the following instructions when working with electrical parts:
When testing the voltage in electrical cables, only use a diode test lamp
(1 8, page 3) or a voltmeter (1 9, page 3).
Test lamps with an illuminant (1 12, page 3) take up voltages which are
too high and which can damage the vehicle's electronic system.
When making electrical connections, ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp edged ducts without protection (3, page 4)
Insulate all connections.
Secure the cables against mechanical wear with cable binders or
insulating tape, for example to existing cables.
The camera is watertight in accordance with IP69K. The sealings on the camera
can therefore withstand a high-pressure cleaner (4, page 4). However, you
should observe the following instructions when handling the camera:
Keep a distance of at least 50 cm between the nozzle of the high pressure
cleaner and the camera.
Do not open the camera, as this impairs the sealing and the function of
the camera (5, page 4).
40
All manuals and user guides at all-guides.com
PerfectView