Waeco PerfectView CAM26W Instrucciones De Montaje Y De Servicio página 55

_RV-HD-STANDARD.book Seite 55 Montag, 28. November 2005 3:46 15
PerfectView
Establishing the electrical connection for the camera
The principle circuit diagram can be found in fig. x, page 12.
Lay the camera cable so that should you need to remove the
camera, you can access the plug connection between the
camera and the extension cable easily. This considerably
eases dismantling work.
➤ Guide the camera cable into the vehicle interior.
➤ Insert the plug of the camera cable into the socket of the extension cable
(b A, page 7).
Tip!
To minimise corrosion in the plug, apply a small amount of grease
– such as pin grease – inside the plug.
Caution!
The plug connections of the extension cable do not offer any
protection against water penetration. It is essential that you wrap
the connection with sealing tape (b B, page 7). The most suitable
tape for this is self-vulcanising tape from 3M, for example.
9 Setting the rear view system
Before you can use the rear view video system you need to set the camera
and the monitor.
Testing functions
Conduct the functional test as follows:
➤ Switch the ignition on.
➤ Switch the POWER switch (9 1, page 5) on the monitor to STDBY.
✓ The status LED on the monitor illuminates.
➤ Switch the CAMERA switch (9 6, page 5) to C1.
➤ Engage reverse gear.
✓ The monitor switches on and displays an image.
➤ Set the brightness and contrast on the monitor as desired
(see "Using the rear view video system" chapter on page 56).
➤ Switch the vehicle light on.
✓ The picture on the monitor becomes slightly darker.
All manuals and user guides at all-guides.com
Setting the rear view system
55