InSinkErator C1300 Instalacion, Cuidado & Uso página 5

2
INSTALLING THE FAUCET - H778
A
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
B
Fiber
Gasket
Make sure to use fiber gasket
to ensure proper seal.
C
An assistant may be needed to hold
the dispenser head in place
while securing the dispenser.
D
Half moon shaped metal washer
should cradle all descending tubes.
All manuals and user guides at all-guides.com
H778
■ ■
Unpack dispenser components.
■ ■
On a firm, flat surface, carefully
straighten the copper tubing.
H778
■ ■
Ensure that the fiber gasket is
properly seated against the base of
the dispenser head.
DO NOT remove mounting screw or
fiber gasket from base of dispenser.
H778
■ ■
Feed tubes down the hole in the sink
or countertop until the base is at rest
on the sink or countertop surface.
■ ■
Position faucet head at the desired
angle.
H778
■ ■
From below the sink, place semi-
circular metal mounting washer over
the mounting screw, ensuring the
mounting washer extends beyond
the sink hole.
■ ■
Slide washer over so that the screw
is now inside the smaller hole.
Tighten the screw until snug.
For Technical Assistance
1-800-845-8345
5