Kuppersbusch DD9840.0S Manual De Uso página 8

4. CONTROLS
On initial start-up the board recognises the mains frequency.
Recognition is signalled on the display by the fact that led G flashes and the panel shuts down.
Wait 10s. to allow the control board to perform calibration, before accessing the commands.
Button Function
The button only works when the door is open.
A
Press Briefly = Turns the Lights On/Off at maximum intensity.
Press and hold for 2 Seconds = Turns the Courtesy Lights On/Off.
Only works with the Door Open.
Press briefly = Activates/Deactivates Delay mode, causing automatic shutdown
of the Motor and the Lighting system from any speed with a 30' delay. It is disabled
by pressing the same button again, turning the motor off or closing the door.
Warning! This mode does not work if INTENSIVE mode has been activated first.
Works both with the Door Closed and Open.
Press and hold for 2 Seconds = With the filter alarm triggered the Filter Alarm
B
is Reset, all leds flashing 3 times. These indications are only visible when the
motor is turned off.
Only works with the Door Open.
Press briefly = Activates speed four.
Only works with the Door Open.
Press and hold for 2 seconds = Enables/Disables the Intensive speed. This
C
speed is timed to run for 6 minutes. At the end of this time the system will return
to the speed set previously.
It is disabled by pressing the same button again, turning the motor off or closing
the door.
Only works with the Door Open.
D
Activates speed three.
Only works with the Door Open.
Activates/Deactivates speed two.
E
Works both with Door Closed and Open with Motor + Lights = Off.
Press and hold for 4 Seconds = Enables/disables the Keyboard lock.
Only works with the Door Open.
Press briefly = Activates/Deactivates speed one.
Door Open or Closed
F
Press and hold for 2 Seconds = Enables/Disables the Activated Charcoal Filter
Alarm with the Motor turned off and no Filter Alarm triggered.
Door Open
Press briefly = Turns the Motor off.
Door Open or Closed
G
Press and hold for 2 Seconds with Motor and Lights Off = Enables/Disables the
Remote control.
Door Open
Press briefly = Closes the Door + Lights and Motor Off
H
Door Closed
Press briefly = Opens the Door + Lights and Motor On.
Warning: If the Door remains partially open for any reason, press the Button to
complete the opening or closing cycle.
8
Led
-
Fixed LED button A.
Fixed LED button A.
LED Button B+ Button for the set Speed are lit.
Fixed LED button:
Indicates the need to wash the metal grease filters.
The alarm is triggered after the Hood has been in
operation for 100 working hours.
Flashing LED button:
Indicates the need to change the activated charcoal
filters, and also to wash the metal grease filters.
The alarm is triggered after the Hood has been in
operation for 200 working hours.
Fixed LED button C+G.
Flashing LED button C.
Fixed LED button G.
Fixed LED button D+G.
Fixed LED button E+G.
All the LED buttons flash twice. During the Lock the
LED buttons light up in sequence.
Fixed LED button F+G.
LED button B flashes twice = Activated Charcoal
filter Alarm Activated.
LED button B flashes once = Activated Charcoal
filter Alarm Deactivated.
LED button goes out.
LED button G + F flashes twice = Remote control
Enabled.
LED button G + F flashes once = Remote control
Disabled.
-