Battery Installation; Handset Battery Charging; Low Battery; Battery Life - Clarity Power 440 Guia Del Usuario

PM080404_C440_RevB_E#34CA7F.qxd

BATTERY INSTALLATION

The C440 uses a 3.6Volt 600mAHr NiMH
rechargeable 3 cell (AAA Type) battery that is
included with your unit.
Handset Battery Must be Connected Before
Beginning Initial Charging
Installing and Connecting Battery
To connect battery, remove battery compart-
ment cover and connect battery pack plug
into the battery connector and replace the
battery compartment cover.
Note: The battery in the handset must be fully
charged for 12 hours before using the
telephone for the first time.
To Install a New Battery:
1. Remove battery cover
2. Install new battery
3. Connect battery pack
4. Replace battery cover
5. Charge for 12 hours
before first use
10
All manuals and user guides at all-guides.com
8/14/04 15:08 Page 10
Getting Started

Handset Battery Charging

1. Place the handset in the base. The
CHARGE LED on the base will light RED.
2. After the batteries are fully charged,
check for dial tone by pressing TALK
on the handset.

Low Battery

When the handset battery gets low, there will
be two (2) beeps every thirty (30) seconds
and the LCD screen will show BATTERY LOW.
If the battery becomes low while you are on
a call, you will be disconnected after about
two (2)
minutes. Terminate the call and recharge
the battery. To recharge the battery pack,
place the handset in the base.
The battery charge can also be monitored via
the battery charge icon. This icon appears
while the phone is in the stand by mode and
indicates the condition of the batteries.
1. Make sure the contact points are
touching and the CHARGE LED is lit.
2. Be careful not to short battery with
conducting materials such as rings,
bracelets and keys.

Battery Life

A fully charged battery provides an average
talk time of about four (4) hours, or standby
time of about (8) days.
Talk time and standby time may vary depend-
ing on operating conditions.