Phottix Strato TTL Manual De Instrucciones página 8

a wireless shutter release). The LED will turn
red when sending a signal or taking a photo.
When idle, the Status LED will go out.
2. The Status LED on the Strato TTL receiver
will flash green once every 2 seconds while
the power is on and in standby. The LED
will turn red when a signal is received from
the transmitter and the connected flash or
camera is fired.
3. When the battery level is low,the Status
LED on the receiver will flash red once every 2
seconds.
Channels
1. The Strato TTL System has 4 transmission
channels: 1, 2, 3, 4.
8
2 . C h a n n e l s c a n b e s e t o n b o t h t h e
transmitter and receiver.
Setting Channels on the Transmitter
1. Press the Channel Selection Button on the
transmitter.
2. Each press of the button will cycle through
channels 1, 2, 3, 4.
3. Make sure the transmitter channel is the
same as the receivers.
4. Channels are visible on the transmitter LCD.
Setting Channels on the Receiver
1. Move the Channel Selection Switch to
settings 1, 2, 3, or 4.