USING THE PRODUCT
DISPLAY
The display shows current information such as distance, elapsed or remaining time, remaining calories, etc.
BUTTONS
•
TOTAL RESET: Press this key and the console will enter directly into reset mode. All data will be deleted.
•
RECOVERY: After training, press the RECOVERY key, all display functions will stop immediately, except TIME which
starts counting down from 00:60 to 00:00.
•
ENTER: Press to select the desired function.
1.
In function selection mode, press the ENTER key to confirm the function.
2.
In setting mode, press the ENTER key to confirm the setting.
3.
In training mode, press the ENTER key to stop/start.
4.
Each time the user presses the ENTER key, there will be a Bibi sound.
•
UP AND DOWN: Press up or down to adjust each function. Press RESET to reset the value to zero. In standby
mode, press ENTER+UP for 3 seconds to turn off the display.
•
RESET: Press this button to clear the current function value or return to the previous function in function selection
mode. Press RESET for 3 seconds to enter standby mode.
FUNCTIONS
•
AUTO ON/OFF: The monitor will turn on when you start paddling or when you press ENTER. If there is no BPM
signal for more than 5 seconds the system will stop automatically.
•
TIME: Count your training time while exercising.
•
DISTANCE : Displays the distance accumulated during the exercise.
•
STROKE COUNTER : Count your strokes while exercising.
•
CALORIES: Displays calories expended during exercise.
RANGE OF VALUES
•
TIME - 00:00 a 99:00 minutes/seconds. 1 minute increments.
•
DISTANCE - 0 a 99.99 KM. Increments of 0.5 km.
•
CALORIES - 0 a 9999 Kcal. Increase of 10klcal.
•
STROKE COUNTER: 0 a 9999 strokes. 1 stroke increments.
•
PULSE: 30-240 BPM. 1 BPM increments.
BATTERY
If there is a problem with the display, try replacing the battery or check if the cable is properly connected. The display
uses two AA batteries.
NOTE: Do not mix battery types or old and new batteries. The monitor will turn off after being
idle for 4 minutes.
42