Ego Power+ ZT5200L Manual Del Operador página 26

4. Use the Allen key D to thoroughly tighten the steel rails onto
the suspension base with the remaining two socket head
screws B (Fig. 8).
WARNING: When finishing tightening the two backside screws,
please check that there is no gap between the front part of the steel
rails and the suspension base.
5. Place the flexible cable into the hook as the indicated position
label on the cable shows (Fig. 9).
C. ATTACHING THE LAP BARS
1. Lift the left lap bar marked with "L" to align the holes in the lap
bar with the holes in the left mounting pole (also marked with
"L"). Select the preferred lap bar operating height:
- Upper two holes in the mounting pole;
- Middle two holes in the mounting pole;
- Bottom two holes in the mounting pole.
2. Use two bolts A to attach the lap bar to the mounting pole
using the wrench C (Fig. 10).
3. Attach the right lap bar (marked with "R") in the similar
fashion using the same pair of holes on the right mounting
pole (marked with "R"). NEVER install the lap bars at an
asymmetrical height.
NOTICE: The left and right lap bars should be adjusted so that they
align with each other when in the neutral position.
26
56-VOLT LITHIUM-ION ELECTRIC ZERO TURN MOWER — ZT5200L/ZT5200L-FC
8
9
Hook
Cable
10
Vertical Alignment
CORRECT
INCORRECT
R
R
A
Mounting Pole
A
B
Steel Rails
B
D
Horizontal Alignment
CORRECT
INCORRECT
Lap Bar
L
C
A
B