Vimar ELVOX SW230.T Manual De Instrucciones Para La Conexión Y El Uso página 34

SW230.T / SW230.T.120
10.5. SINGLE LEAF learning procedure WITH deceleration.
1. Begin the procedure with the gate closed.
2. Press push button P1 and hold it down. LED DL7 starts to flash (1
3. Do not release push button P1. The flashing becomes faster (2
4. Do not release push button P1 until it flashes faster (3
5. Release push button P1.
6. Follow the programming phases shown in the figure.
7. Programming ends when LED DL7 stops flashing.
CAUTION: After resetting or powering the board, the travel time of the first closing manoeuvre increases by approximately 5 seconds to allow the
completion of motion in any case.
1 START
st
DECEL.ZONE OP. M1
2 START
nd
3 START
rd
10.6. SINGLE LEAF learning procedure WITHOUT deceleration.
1. Begin the procedure with the gate closed.
2. Adjust trimmer TR3 SL to the maximum setting (complete clockwise rotation), thereby excluding deceleration.
3. Press push button P1 and hold it down. LED DL7 starts to flash (1
4. Do not release push button P1. The flashing becomes faster (2
5. Do not release push button P1 until it flashes faster (3
6. Release push button P1.
7. Follow the programming phases shown in the figure.
8. Programming ends when LED DL7 stops flashing.
CAUTION: After resetting or powering the board, the travel time of the first closing manoeuvre increases by approximately 5 seconds to allow the
completion of motion in any case.
1 START
st
2 START
nd
34
flashing frequency).
st
flashing sequence).
nd
flashing frequency).
nd
The first START begins the
learning process by moving
MOTOR 1 in opening
(Caution! start with the
gate closed)
The second START
sets the starting point
of MOTOR 1 opening
deceleration
The third START sets the
MOTOR 1 travel end and
should be pressed when
leaf 1 reaches the stop
flashing frequency).
st
flashing sequence).
nd
flashing frequency).
nd
The first START begins the
learning process by moving
MOTOR 1 in opening
(Caution! start with the
gate closed)
The second START sets
the MOTOR 1 travel end
and should be pressed
when leaf 1 reaches the
stop
EN
DECEL.ZONE CL. M1
4 START
th
5 START
th
3 START
rd
The fourth START sets the
starting point of MOTOR 1
closing deceleration
The fifth START sets the
MOTOR 1 travel end and
should be pressed when
leaf 1 reaches the stop
To complete programming,
wait for the gate to be
completely closed and LED
DL7 to be off
The third START sets the
MOTOR 1 travel end and
should be pressed when
leaf 1 reaches the stop
To complete programming,
wait for the gate to be
completely closed and LED
DL7 to be off