5) The display shows REPEAT, input the new PIN code again.
6) Press
to confirm, the code will be stored and a tone sounded.
BASE DEFAULT
This function allows the user to restore the base setting to the factory default.
key, then using ∧ ∧ ∧ ∧ or ∨ ∨ ∨ ∨ key to select BS DEFAULT item.
1) Press
2) Press
key to confirm.
3) The user will be prompted to enter the PIN code, the display shows PIN?, then press numerical keys to
input code (default as 0000).
4) Press
key to confirm. If the PIN code is validated all base settings will be returned to the factory
default.
Handset Menu function 4: HS SETTINGS
The user is able to change a number of the settings for the handset to their own individual preferences. Press
key and use ∧ ∧ ∧ ∧ or ∨ ∨ ∨ ∨ key to select HS SETTINGS. Then you can do below:
ALARM
The user can set the alarm on the handset and adjust the alarm settings, to give an alert at a
programmed time of every day.
1) Press
key, the first sub-menu is ALARM item. Press
2) Press ∧ ∧ ∧ ∧ or ∨ ∨ ∨ ∨ key to select ON or OFF, press
off, and the user is dropped back to the ALARM menu surface, selection of ON option will turn the alarm
on, then the user will be requested to set the alarm time.
3) After select ON, press
4) Press ∧ ∧ ∧ ∧ or ∨ ∨ ∨ ∨ key to change the hours, press
minutes, AM/PM.
5) After select the alarm time, press
ON or OFF to enable or disable the snooze function on the alarm.
6) Press
key to confirm your selection.
7) When the alarm is set, the
Startup alarm:
In idle state, the alarm will ring at very sharp time you have set.
Intermit alarm:
During the alarming, you can switch it off by pressing any key of the handset, or when a call comes, the alarm
will be intermitted too.
Close alarm:
Re-enter the alarm setting menu option and select OFF.
NOTE: 1. If the SNOOZE is set ON, the alarm will be repeated about every 5 minutes for about nine times,
with the alarm icon continuing to flash. During the alarming, press any key except
key to intermit alarming, and will begin to ring after 5 minutes.
All manuals and user guides at all-guides.com
key to start the time settings of alarm, "00-00" displayed with "00" is blinking.
key, the user will be presented with a further option to select to
will appear on the top of the display.
25
key to confirm.
key to confirm. Selection of OFF will turn the alarm
key to confirm, use the same method to select
(HANG UP)