Attaching A Dust Collector; Removing The Sanding Belt; Mounting A New Sanding Belt - Holzmann ZS640P Manual De Instrucciones

13.3
The machine is provided with two 4-inch dust chutes. Use ring clamps to attach dust collection
hoses to the chutes.
WARNING
Do not operate this machine without a dust collector attached and running.
13.4
Lift the upper guard and tilt it to the rear, in order to access the sanding drum.
The sanding belt is fixed at either end of the drum by spring loaded clamps. To remove the sand-
ing belt, push the right clamp forward and pull the tab of the sanding belt out of the right drum
slot. Unwind the sanding belt from the drum, and push the clamp forward at the left side of the
drum to remove the sanding belt tab from the left drum slot.
13.5
Insert the tab of the belt on the left end of the drum, and push the left clamp forward so that the
tab will slide under the clamp. Releasing the clamp will lock belt tab into place. Roll the sanding
belt onto the drum, keeping the edges snug. Tuck the tab at the right end of the sanding belt into
the slot at the other end of the drum, pushing the clamp forward so that the tab will slide in. The
clamps are spring loaded, and will hold the belt increasingly tightly as the drum revolves. Replace
and mount sanding belt on both sanding drum by this method.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at

Attaching a dust collector

Removing the Sanding Belt

Mounting a new Sanding Belt

Dust Chute
Lijadora de rodillos / mini wide belt sander ZS640P/ZS970P
Página 26