Black and Decker PW1300 Manual Del Usuario página 13

Caution - Danger!
Check that the electrical supply voltage and frequen-
cy (V-Hz) correspond to those specified on the appliance
data plate (fig.2). The appliance should only be connected
to a mains power supply equipped with an adequate earth
connection and a differential security breaker (30 mA)
to cut off the electricity supply in the instance of a short
circuit.
5.3.1 Use of extension cables
use cables featuring "iPX5" protection
level.
the cross-section of the extension cable
should be proportionate to its length;
the longer it is, the greater its cross-sec-
tion should be. see table i.
5.4 Water supply connection
Caution - Danger!
Only clean or filtered water should be used for intake.
The delivery of the water intake tap should be equal to that
of pump capacity.
Place the appliance as close to the water supply
system as possible.
5.4.1 Connection points
l Water outlet (outLet)
n Water inlet with filter (iNLet)
5.4.2 Connection to the mains water supply
the appliance can be connected direct-
ly to the mains drinking water supply
only if the supply hose is fitted with a
backflow preventer valve as per current
regulations in force. Make sure that the
hose is at least Ø 13 mm and that it is
reinforced.
ADJUSTMENT INFORMATION (FIG.3)

6.1 Adjusting the spray nozzle (for models
with this feature)
Water flow is adjusted by regulating the nozzle (E).
6.2 Adjusting the detergent (on models with
this feature)
Detergent flow is adjusted using the regulator (F).
6.3 Adjusting the detergent pressure
set the adjustable nozzle on "
gent at the correct pressure (on models with this
feature).
6.4 Adjusting the pressure (on models with
this feature)
the regulator (G) is used to adjust the working pres-
sure. the pressure is shown on the pressure gauge
(where fitted).
INFORMATION ON USE OF THE

APPLIANCE (FIG.4)
7.1 Controls
- starter device (H).
set the starter switch on (oN/1) to:
a) start the motor (in models without tss device);
b) set the motor ready to start (in models with tss
device).
if there is a pilot light on the starter device, it should
light up.
if the "low/high" settings are available, use them as
follows:
Low : low pressure washing
high : high pressure washing
set the starter device switch on (oFF/0) to shut down
the appliance.
if there is a pilot light on the starter device, it should
go out.
- Water jet control lever (I).
Caution - Danger!
During operation the appliance must be positioned
as shown in fig. 4 on a sturdy, stable surface.
7.2 Start-up
Caution - Danger!
Before starting up the appliance check that the water
supply hose is connected properly; use of the appliance
without water will damage it; do not cover the ventilation
grilles when the appliance is in use.
on three-phase models for professional use, at first
use start the appliance for a very short time to check
that the motor is running in the correct direction. if
the motor fan is turning anti-clockwise, exchange
two of the three phase wires (L1, L2, L3) in the elec-
trical plug.
1) turn on the water supply tap fully.
2) release the safety catch (D).
3) Depress the gun trigger for a few seconds and
start up the appliance using the starter device
(oN/1).
TSS models - in tss models with automatic delivery
flow cut-off system:
1
English
" to deliver deter-
EN