Cleaning & Maintenance - ADE M112800 Manual De Operación

Tare function
The tare function can be used to disregard an additional weight e.g. a nappy or towel on the
weighing
tray surface. The tare function is operated as follow: Place the object on the tray surface and
press the TARE button. The additional weight will be subtracted and 0.00 will be shown on
the display. A baby
can now be placed on the scale surface and the net weight will appear on the display. The
maximum tare weight must not exceed 500g.
Unit switch function
Press the ON/OFF button twice during the function test. By pressing again the ON/OFF
button you can select the requested units kg or lbs. The kg or lb OZ symbol will appear in
the display to indicate the chosen weighing unit.
Recall of memorized weight
Start the scale via the ON/OFF button and the last measured weight will be displayed for
approx.
3 sec. in order to determined weight changes of the infant.
Cleaning
Clean your scale with a soft moist towel or conventional disinfectant only. Do not use any
aggressive cleaning solutions.
Fault messages
1. Why does the display read 'lo'?
Low battery. Replace the batteries.
2. The message displays 0-Ld
Overload warning; remove the weight immediately; otherwise, permanent damage to the
scale will occur.
Storage and transport
Keep all original parts and pieces for an eventual sending back of the scale in order to avoid
any possible damage during transport which automatically leads to no warranty.
Disconnect all cables before transport to avoid unnecessary damages.
Waste disposal
Electronic devices are not domestic waste.
If the scale is out of use the responsible waste disposal association will be
glad to advise you on the measures necessary to dispose of it properly.
Do not throw used batteries into domestic waste. Please inform yourselves at
the responsible waste disposal association how to dispose used batteries.
12
Cleaning & maintenance
M112800-160118-Rev001-UM-de-e-es-fr-nl