Publicidad
Idiomas disponibles
Idiomas disponibles
You can install the machine in two ways:
a. As a stationary machine on a workbench. In
this case the machine must be secured to the
workbench with 4 bolts.
b. As a stationary machine on the subframe. In
this case the machine must be secured to
the subframe with 4 bolts and the subframe
anchored to the floor or to a floor plate with
dimensions of at least 1 square metre
Assembly of the bench saw on the workbench
Fig. B & C
Before adjusting the saw, make sure the
plug is removed from the socket.
Fig. B shows the distance of the holes to be
drilled in the workbench on which to fasten the
machine. Drill holes of 8 mm.
Only use the machine after it has been
assembled completely and it has been
screwed onto the workbench or the
frame.
• Fig. C shows the part to be sawn out (310 x
310 mm), so that the sawdust can fall through
it and piling up is prevented! Only if you do not
use an extraction system!
• Fasten the machine with bolts.
• If the frame is used, it must be fixed on the
floor with four screws and the machine must
be fixed on the frame with four screws. Check
the screws before switching the machine on.
Assemble undercarriage
Fig. G
• Turn the machine upside down.
• Now place one by one the uprights in the
casing of the sawing bench (Fig. G-4).
• Secure the uprights with 4 screws using a
screwdriver, do not completely tighten the
screws (Fig. G-5).
• Fit the 4 support bars, do not completely
tighten the screws (Fig. G-6)
• Attach the rubber feet under the uprights (Fig.
G-7).
• Turn the machine into an upright position on a
flat surface and adjust the machine so that it
stands in a stable position, tighten all the nuts
and bolts (Fig. G-7).
All manuals and user guides at all-guides.com
Assemble bracket/push stick
• Attach the 2 brackets onto the casing of the
sawing bench and screw them tight (Fig. G-8).
• Place the push stick in the brackets.
Assembly and attachment of the rip fence
Fig. D
• Attach the aluminium fence (A) to the
positioning block (B).
• Now you can attach the complete rip fence to
the bench top.
• Slide the rip fence via one end of the
positioning rail (C) over the bench top.
• Adjust the position of the aluminium fence
profile (A) such that the end corresponds to the
rear edge of the saw.
Assembly of the riving knife and the protective
cap
Fig. E
• Turn the saw blade completely upwards.
• Remove the bench inlay.
• Assemble the riving knife on the set-up for this
purpose and use hereby the Allen screws and
the filling rings. Ensure that the riving knife falls
properly into the opening (= groove).
• Now put the inlay back in the bench and fasten
it.
• Now assembly the protective cap onto the
riving knife and use hereby the profiled nut and
self-locking nut.
• Above the saw table the radial distance
between the riving knife and the toothed rim of
the saw blade shall not at any point exceed 5
mm at the depth of cut set.
• The tip of the riving knife shall not be lower
than 5 mm from the tooth peak, as shown.
Assembly of the saw blade
Now lay a lath against the saw blade and
the riving knife and check whether it falls
properly into the extension of the saw
blade. If this is not the case: Loosen the
fastening bolts and place or remove the
filling rings.
First remove the plug from the mains
before the saw blade is assembled or
replaced.
9
Publicidad
