SEA PALM Manual Del Usuario página 16

Sistemi elettronici
di Aperture Porte e Cancelli
SUMMARIZING BOARD FOR THE USE OF THE TERMINAL
TYPING IN
SEQUENCE
A-A-A
A-A-B
A-A-C
A-B-A
A-B-B
A-B-C
A-B-D
5
SEA S.r.l. SEA S.r.l.
DIREZIONE E STABILIMENTO: DIREZIONE E STABILIMENTO:
Zona industriale 64020 S.ATTO Teramo - (ITALY) Zona industriale 64020 S.ATTO Teramo - (ITALY)
Tel. 0861 588341 r.a. Fax 0861 588344 Tel. 0861 588341 r.a. Fax 0861 588344
TRANSMITTER ADMINISTRATION
DESCRIPTION OF THE OPERATIONS
A: Create Code
Allows to create a radio transmitter code to be used for the
programming of a SmartCopy radio transmitter.
The following parameters can be set: installer code; installation code;
user code; once the radio transmitter code has been created it is
possible to send it for the programming of a SmartCopy by pressing
pushbutton D. In this last screen it is possible to increase the code and
to transmit it again (press pushbutton D again) to another radio
transmitter or pressing pushbutton B it is possible to read the code of
the radio transmitter.
The terminal is ready for reception and waits for ca. 7 seconds
for the transmitter code (press the radio transmitter channel you want
to read)
The terminal is ready for reception and waits for ca. 7 seconds
for the transmitter code (press the radio transmitter channel you
want to read), memorizes it in his temporary memory, allowing in this
way to memorize said code in an eventual memory module which is
inserted in the special memory Slot.
ADMINISTRATION OF THE MEMORY
Allows to read the Chip of external memory which has been
correctly inserted into the Memory slot and to visualize the radio
transmitter codes which it contains.
Allows to modify the contents of the external memory so to add
or to remove radio transmitter codes. In this phase it is possible to
add a single radio transmitter or to make a sequencial
programming.
Infact inserting a new code ther will appear the request for the
quantity of radio transmitters to be inserted.
In case of a single transmitter insert value 1, in case of more radio
transmitters insert the quantity paying attention that the code of the
first transmitter corrisponds to the one inserted as "new".
Allows to write the external memory and to memorize the
eventually made modifications.
Erases the whole contents of the external memory (formatting)
http://www.seateam.com http://www.seateam.com
e-mail:seacom@seateam.com (Uff. Comm.le) e-mail:seacom@seateam.com (Uff. Comm.le)
English
Rev. 04 - 09/2007