Master Volume - HH Electronics TRE-1201 Manual Del Usuario

TENSOR SERIES ACTIVE LOUDSPEAKER
REAR PANEL CONTROL PANEL - THIS IS THE SAME FOR BOTH MODELS.
1 & 2. INPUTS: A Combi Input allows for the use of
both XLR and 1/4" Jacks and accepts balanced and
unbalanced signals.
Note: a stereo signal on TRS lead cannot be connected
directly, and must be split to two mono connectors.
GAIN: Use to set the channel level.
Note: Set the Gain control to minimum before connecting an
audio signal.
Once the system is powered up, we recommend that the
Gain set to midway is a good starting point.
3. MASTER VOLUME: Controls the overall level of
your Tensor system.
Note: Set this control to minimum when switching the unit ON
or Off.
LIMIT: The Tensor cabinets are equipped with an
onboard limiter to prevent overload to the power
amplifiers and loudspeakers. The Limit led will illuminate
when the Limiter is active. Occasional blinking of the
Limit led is ok, but continuous illumination could result in
damage to the system and Main Volume should be
reduced.
4. MIX OUT: A signal feed which can be used to
connect a second Tensor cab (daisy chained - see page 5),
active wedge monitor, house PA or recording console for
example. The MIX OUT signal level is not affected by the
VOLUME CONTROL.
5. EQUALISATION: Four presets are included to
optimise the response of the cabinet to suit your needs.
Cycle through them using the Mode button.
MUSIC: A bass lift with a flat mid to high response.
LIVE: Similar to the 'MUSIC' response with the LF lift frequency
shifted.
MONITOR: A LF and HF roll-off with a
for clarity.
VOCAL: A bass roll-off with flat mid and upper frequencies.
The EQ setting is stored and recalled following a power cycle. Please
note the unit is shipped with the EQ mode set to "MUSIC."
6. OPTION: A Ground lift has been provided to reduce the potential
problem of earth loops when connecting to other equipment. This
control is to be used in conjunction with the MIX OUT.
The Cabinets front logo illumination can be turned ON/Off with the
Logo control.
© 2020 HH Electronics Ltd
with a slight mid band cut
Designed and Engineered in the UK by HH Electronics LTD.
2
1
INPUT 1 INPUT 2
0 0
LINE MIC LINE MIC
GAIN GAIN
INPUT 1 INPUT 2
DESIGNED AND ENGINEERED IN THE UK
WWW.HHELECTRONICS.COM
3
MAIN MODE
5
MUSIC
MODE
LIVE
LIMIT
MONITOR
VOLUME
VOCAL
LOGO
MIX OUT OPTION
4 6
3