Quick Tips - HH Electronics TRE-1201 Manual Del Usuario

TENSOR SERIES ACTIVE LOUDSPEAKER
FITTING EYE BOLT
A: To fit the eye bolts, first locate and remove the four
rubber protection caps (positions shown below).
4
3

QUICK TIPS

Use electronic safety devices such as circuit breakers.
Ÿ
Master volume should be at zero for switch on and off.
Ÿ
Use input gain to set maximum signal level without distortion.
Ÿ
Set up microphone levels first, and adjust other equipment to match.
Ÿ
Avoid very high onstage levels from back-line amps.
Ÿ
Avoid damp environments and extremes of temperature for storage and use of all audio equipment.
Ÿ
Look after your cables. Do not stand equipment on, or run cases over them, do not tie knots in them and always use them
Ÿ
for the correct application (a signal lead is NOT a speaker lead). Coil and secure with cable ties before storing.
Ensure your equipment is properly loaded and cannot move around during
Ÿ
Keep lights away from speakers; heat can cause fires/speaker damage.
Ÿ
Don't run cables across access-ways; if you have to, run them above doors or use approved cable covers.
Ÿ
Be aware of total power usage. Overloading a mains socket is potentially dangerous, and likely to cause a power out during
Ÿ
use.
Ÿ Keep power and signal cables apart.
© 2020 HH Electronics Ltd
1
2
Designed and Engineered in the UK by HH Electronics LTD.
B: Replace with a suitable eye bolt. Ensure thread is fully engaged
into the insert.
Note that eye bolts for flying systems must be cast, shouldered
fittings rated for the purpose.
Forged steel eye bolts of the type typically available from
DIY suppliers are NOT suitable and should not be used
under any circumstances.
M8 thread
transit.
20mm minimum thread length
9