HH Electronics TRE-1201 Manual Del Usuario página 8

TENSOR SERIES ACTIVE LOUDSPEAKER
CONFIGURATIONS
The intuitive design of the Tensor cabinets provide user flexibility and a product that will serve in many situations:
A: Tripod/pole mounting - via the 35mm pole socket.
B: Pole on sub.
C: Flown vertically.
D: Flown horizontally.
E: Freestanding - on the ground.
F: Monitor mode - the cabinets shape allows for horizontal/angled position on stage.
A
(Stand not included)
IMPORTANT
POLE MOUNT: Don't over-extend poles/tripods; ensure at least 4 x the pole diameter is still inside the outer pole. Make sure
the legs have a good splay on tripods, but do not obstruct doorways or other access-ways. Make sure that the thumb screw on the
cabinet is tight.
SUSPENDED
WARNING: The suspension or 'flying' of cabinets should be performed only by properly qualified persons, in compliance with all
local laws.
The position of installation is also bound by laws and regulations so must be taken into account in the initial planning stages.
Hardware used must be fully approved for its intended use and be rated to support weights greater than that of the cabinet.
All installation equipment used is subject to regular safety checks which must be strictly adhered to.
If any of the hardware shows any signs of wear or damage, it should be replaced immediately.
Failure to do so could result in serious injury or death!
© 2020 HH Electronics Ltd
B
Designed and Engineered in the UK by HH Electronics LTD.
C
E
D
F
8