Warnings And Cautions; Important Safety Instructions; Mounting Instructions - ecolight AC1041-AL3-03LF3-E Manual Del Usuario

Warnings and Cautions

CAUTION
DO NOT USE THIS FIXTURE WITH A DIMMING CIRCUIT. If dimmer
•
controls are present, remove them and replace them with regular
electrical switches. If a three-way dimmer is present, replace it with a
regular three-way switch. If unfamiliar with electrical installations, it is
recommended a qualified electrician do the installation.
• This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

Important Safety Instructions

This unit has a polarized plug (one blade is wider than the other) as a safety
feature. This plug will only fit in a polarized outlet one way. If the plug does
not fit completely into the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. Never use with a power strip unless the plug
can be completely inserted. Do NOT attempt to defeat this feature.
WARNING: To reduce the risk of FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS:
1. For INDOOR USE ONLY.
2. Do NOT touch LEDs.
3. Do NOT remove the protective clear LED lens.
4. Do NOT look directly at lighted LEDs for any length of time.
5. Do NOT touch, operate, or install fixture while in contact with water.
6. Not intended for illumination of aquariums.
7. Not intended for recessed installation in ceilings or soffits.
8. Do NOT mount over sinks or stoves.
9. Do NOT mount the fixture to cabinets having a material thickness less
than 1/4 in.
10. Lights may be installed inside of enclosed cabinets ONLY when the
POWER CONTROL UNIT and 120 V POWER CORD are located
outside of the cabinet.
11. Electrical requirements:120 V, 60 Hz, 0.18 A MAX.
12. Do NOT attempt to install while plugged in.
13. Do not use an extension cord. Use a power strip with integral
over current protection to supply power to the fixture.
14. Use only insulated staples or plastic ties (not included) to secure the cords.
15. Do not run ANY cords behind walls, ceilings, soffits, cabinets or a similar
permanent structure where it may be inaccessible for examination.
SAVE THESE INSTRUCTIONS IN A LOCATION CLOSE TO THE FIXTURE TO
REFER TO THEM AT A LATER TIME.

Mounting Instructions

Take into consideration the location of the power control unit (on/off switch and dimming
control), the power hub, and the puck connector cord before mounting the pucks. NOTE: The
power control unit must be within 5 feet of an electrical outlet, the power hub must be within
24 inches of the power control unit, and the pucks must be mounted within 36 inches of the
power hub. Measure and mark the mounting surface before drilling holes into cabinets to
ensure proper placement.
1
2
3
4
The pucks may have the mounting caps pre-installed on the
top of the pucks (depending on the production run). Rotate
the cap counter clockwise and remove them.
Locate the positions on the mounting surface where the pucks
are to be mounted and mark the center location of each puck.
Once the center points of the pucks have been determined,
hold each mounting cap in place and mark the two holes.
Dimple the surface with either an awl, a nail, or drill a small
pilot hole for the cap screws. Secure the mounting caps with
the two cap screws provided.
Once the mounting cap is secure, bring the puck to the
mounting cap, engage the catches on the puck with the
groves on the cap and turn clockwise.
- 2 -