Airwell CDMX-035N-09M25 / YDAX-035H-09M25 Manual De Instrucciones página 43

Water condensation
CAUTION
Failure to tighten screws can cause water
leakage.
Gap not allowed
CAUTION
If the unit is not hung correctly and a gap exists,
the unit' s height must be adjusted to ensure
proper function. The unit' s height can be
adjusted by loosening the upper nut, and
adjusting the lower nut.
Compact models
Step 1: Remove the front grille.
1. Push both of the tabs towards the middle
simultaneously to unlock the hook on the
grille.
Grille hook
2. Hold the grille at a 45° angle, lift it up
slightly and detach it from the main body.
Step 2: Install the panel
Align the indicate "△" on the decoration
panel to the indicate "△" on the unit .
Attach the decoration panel to the unit with
the supplied screws as shown in gure below.
Loosen upper nut
Adjust lower nut
Step 3: Mount the intake grille.
Step 4: Connect the 2 wires of the
After installing the decoration panel, ensure
that there is no space between the unit body
and decoration panel. Otherwise air may leak
through the gap and cause dewdrop. (See
gure below)
Ensure that the buckles at the back of the
grille be properly seated in the groove of the
panel.
decoration panel to the mainboard
of the unit.
Decoration panel
Screws (M5)
(supplied with
the panel)
Page 42
 