Energy Saving Tips - Kunft KDD4870 Manual De Instrucciones


Stop block
‚
Selt-tapping screw

‚
Screw hole covers Screw hole covers

‚
ƒ
Lower hinge parts (right)

‚ Adjustable bottom feet part
ƒ Self-tapping screws
26
8. Place the lower door on a
smooth surface with its panel
upwards. Loose the screw

and the stop block , install
them on the left side and
tighten securely.
9. Change the screw hole covers
of the middle cover plate from
left to right (as shown).
10. Lay the refrigerator on a soft
foam packaging or similar ma-
terial. Remove both adjustable
feet parts, and the lower hinge
part by unscrewing the special
flange self-tapping screws.
11. Replace the lower hinge part
to the left side and fixing it with
the special flange self-tapping
screws. Replace the adjusta-
ble feet parts to another side
and fixing it.
12. Transfer the lower door to the
property position, adjust the lo-
wer hinge part, make the hinge
axis into the lower hole of the
lower door, then tight the bolts.
refrigerator freezer
‚
Upper hinge part
Upper hinge cover (left)
17. Open the upper door and install the door shelves, then close it.
Warning!
When changing the side at which the door opens, the appliance must
not be connected to the mains. Remove the plug from the mains
beforehand.

Energy saving tips

• We recommend that you follow the tips below to save energy.
• Try to avoid keeping the door open for long periods.
• Make sure the appliance is away from any sources of heat (Direct
sunlight, electric oven or cooker, etc.)
• Don't set the temperature colder than necessary.
• Don't store warm food or evaporating liquid in the appliance.
KDD4870
13. Upturn the middle hinge part
Middle hinge
180 degrees, transfer it and
part
adjust its position, secure the
Selftapping
middle hinge axis into the
screws
upper hole of the lower door
and tighten the bolts.
14. Transfer the upper door to the
appropriate position. Secure
the door's level and secure the
middle hinge axis into the lo-
wer hole of the upper door.
15. Transfer the upper hinge part
and make the upper hinge axis
into the upper hole of the upper
door, and adjust the position of
the upper door (please support
the upper door with your hand
when doing it), fixing the upper
hinge part with the special flan-
ge self-tapping screws.
16. Install the screw hole cover on
Screw hole cover
the top right corner of the refri-
gerator. Install the upper hinge
cover (which is in the plastic
bag) on the left corner. Put the
other upper hinge cover into
the plastic bag.
27
EN