Whispbar K499W Instrucciones De Montaje página 38

GB
Fitting Kit
K499W
Use two M5 x 12 mm self tapping screws to
secure the assembly onto the leg.
Do not over tighten.
Fitment
Locate two holes at each position along the
inside of the roof rails.
Attaches to factory-fitted mounting points. Do
not use rear fixpoint.
Place crossbars approximately above these
holes on roof rails.
Ensure back edge of foot sits flush with the
back edge of vehicle roof rail.
NOTE: FRONT CROSSBAR ONLY
Ensure the clamp point faces towards the
front of vehicle.
38