Items Supplied; Technical Data; Proper Use - EINHELL TC-MC 355 Manual De Instrucciones

21 Stop screw
22 Lock nut
23 Shaft screw
24 Outer fl ange

2.2 Items supplied

Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made bought the product
within the maximum days indicated by the con-
sumer protection laws of your country and upon
presentation of a valid bill of purchase. Also, refer
to the warranty table in the service information at
the end of the operating instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Metal cutting-off machine
•
Cutting-off wheel for steel
•
Universal key
•
Original operating instructions

3. Proper use

The metal cutting-off machine is designed for cut-
ting metal commensurate with the machine's size.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Anl_SA_TC_MC_355_SPK8.indb 31 Anl_SA_TC_MC_355_SPK8.indb 31
GB
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
All persons who use and service the equipment
have to be acquainted with these operating
instructions and must be informed about the
equipment's potential hazards. It is also imperati-
ve to observe the accident prevention regulations
in force in your area. The same applies for the
general rules of health and safety at work.
The manufacturer will not be liable for any chan-
ges made to the equipment nor for any damage
resulting from such changes.
Even when the equipment is used as prescribed
it is still impossible to eliminate certain residual
risk factors. The following hazards may arise in
connection with the equipment's construction and
design:
•
Contact with the cutting-off wheel in the unco-
vered cutting zone.
•
Reaching into the cutting-off wheel while it is
running (injuries through cutting).
•
Kick-back of workpieces and parts of work-
pieces.
•
Broken cutting-off wheels.
•
Catapulting of damaged or cutting-off wheels.
•
Damage to hearing if essential ear-muffs are
not used.

4. Technical data

See warranty card of your country.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 60745.
Warning!
The specifi ed vibration value was established in
accordance with a standardized testing method. It
- 31 -
11.04.2018 08:57:10 11.04.2018 08:57:10