Publicidad
Step 6
NOTE: Be sure the METAL BRACKETS (U) on the LONG SKIRTS (M)
å
are positioned toward the fl oor.
NOTE: Be sure the grooves in the SKIRTS are facing in as shown.
å
Follow the diagram closely.
Slide two FEET (R) into the grooves in the LONG SKIRTS (M) and
å
SHORT SKIRTS (N) as shown. You may need to gently tap them in
with your hammer. Follow the diagrams closely.
Now, fasten the FEET (R) to the BOTTOM (H). Use two BLACK 9/16"
å
WAFER HEAD SCREWS (AA) through the large holes in the FEET.
NOTE: Be sure to use the 9/16" WAFER HEAD SCREWS (AA). Start
å
both SCREWS a few turns before tightening either of them.
Next, fasten the METAL BRACKETS (U) on the LONG SKIRTS (M) to
å
the BOTTOM (H). Use two BLACK 9/16" LARGE HEAD SCREWS (BB)
BLACK 9/16" LARGE HEAD SCREW
(2 used for the METAL BRACKETS)
Page 10
R
N
BB
109872
BLACK 9/16" WAFER HEAD SCREW
(2 used for the FEET)
U
M
M
H
AA
R
N
www.sauder.com/services
Publicidad
