Barrette SELECT Serie Manual Del Usuario página 4

6.
Installing Bottom Rail:
a. Slide rail bracket cover onto ends of railing
(Fig. 6).
b. Place brackets onto both ends of bottom rail
(make sure to use brackets without side holes)
(Fig. 6).
c. Slide bottom rail in between posts and rest on
top of wood spacer blocks (Fig. 7).
d. Using
screw hole. On angle, drill through bracket
hole, vinyl post jacket and vinyl insert (Fig. 8).
e. Drive the first #10 x 1
bracket into post (Fig. 9).
f. Repeat steps d & e for the remaining three
screws for the first bottom bracket.
g. Repeat steps d, e & f for the second bottom
bracket.
h. Snap covers over exposed brackets to hide
screws.
7.
Snap Balusters Into Your Bottom Rail:
a. Lock tabs on baluster/spindle must face outer
edge of routed holes (Fig. 10).
b. Push all balusters into bottom rail, ensuring
that all baluster tabs lock into rail (Fig. 11).
4
⁄ " drill bit, pre-drill first bottom bracket
5
32
⁄ " screw through bottom
1
4
Fig. 10
Lock Lock
Tabs Tabs
Outer Edge Outer Edge
Fig. 11
Fig. 6
Fig. 7
Fig. 8
Fig. 9