Barrette SELECT Serie Manual Del Usuario página 9

5.
Cutting Rails:
Remove clamped stair kit from posts. Cut along all
four angled marks on rails (Fig. 6).
6.
Slide the stair brackets onto the rails (Fig. 7) and
place rail section between your posts (Fig. 8).
7.
a. Mark all bracket holes. Pre-drill all bracket holes
with
b. Drive screws through brackets into post using
#10x 1
bracket) (Fig. 10).
8.
a. Pre-drill through one side of the top rail bracket
using
bracket (Fig. 11).
b. Drive the top rail set screw through the bracket
and rail to secure in place. DO NOT overtighten
the screw or bracket may crack. Repeat for
opposite bracket.
⁄ " drill bit (Fig. 9).
1
8
⁄ " self-tapping square drive screws (4 per
1
4
⁄ " drill bit at a location 1" from end of
5
32
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
1"
9