Evolution 0M-900CE Manual De Instrucciones página 14

SETUP (Continued)
ASSEMBLY INSTRUCTIONS:
STEP 1: Loosen the cylinder attachment knob.
STEP 2: Lower the EVOLUTION conserver over any CGA-870 post-valve cylinder
with the alignment pins toward the holes on the cylinder neck [see Fig. B].
STEP 3: Line up the two pins and the seal washer (gasket) with the corresponding
holes on the cylinder post valve.
STEP 4: While holding the unit in place, tighten the cylinder attachment knob
by turning clockwise [see Fig. B].
NOTE: The cylinder attachment knob should be aligned with
the indentation on the post valve.
NOTE: Tighten only by hand. The use of a tool to tighten the
knob may damamge the unit.
STEP 5 : A ttach a standard cannula (7 ft. [2.13 m] or less in length) to the oxygen supply outlet . See Figure F for an illustration
demonstrating the proper positioning of the nasal cannula.
14
TM
FIGURE E
Attaching th e
E VOLUTION to the
TM
conserve r.