4 – Front and Rear Panel Features
1
2
3
4
5
6
7
8
9
•
H
Levelers: The levelers provide long-term support for the UPS system.
10
•
I
Casters: The casters are designed for small position adjustments within the final installation location only; they are not designed for moving
the UPS system over longer distances. The casters are not designed to provide long-term support for the UPS system after final installation.
Use the levelers to provide long-term support.
•
Accessory Slot: Remove the cover panel to install a Tripp Lite SNMPWEBCARD accessory. The SNMPWEBCARD accessory provides an
J
Ethernet interface for the UPS system and enables remote monitoring and control via SNMP, Web browser or telnet. Visit www.tripplite.com
11
for more information about the SNMPWEBCARD accessory.
•
RS-232 Serial Communications Port: This DB9 port connects the UPS system to compatible workstations or servers, enabling automatic
K
shutdown during extended blackouts and monitoring of operating and power conditions.
•
L
Parallel Configuration Port: These DB9 ports connect the UPS system to another UPS system, or chain of systems, of identical type and
12
capacity for use in a parallel configuration (up to 4 systems).*
*A pair of DIP switches are set to 1/On or 0/Off on each UPS, depending on the parallel configuration.
•
Input Dry Contact Interface: This interface receives dry contact signals that allow the UPS system to receive commands and monitor
M
external battery conditions. See
13
•
Output Dry Contact Interface: This interface allows the UPS system to send information via dry contact communications. See
N
Communications
for more information.
•
Terminal Block Cover: Remove the terminal block cover to access the UPS system's input, bypass input, external battery cabinet, output and
O
grounding connection terminals. Wiring conduits pass through the circular knockouts in the terminal block cover. See
14
more information, including a detailed diagram of the terminal block.
12-212-93-3141.indb 8
L
H
I
Rear View
Section 11 - Communications
for more information.
(continued)
J
M
K
N
O
H
I
8
Section 11 –
Section 6 – Wiring
for
12/28/2012 11:17:05 AM