Midi Implementation Chart; Setup; Input Mode; Output Mode - Phonic DFX 2000 Manual Del Usuario

MIDI Implementation Chart

Function
Basic Channel
Note Number
Velocity
After Touch
Pitch Bender
Control
Program Change
System Exclusive
System Common
AUX messages

SETUP

Input Mode

By pushing the Setup button, users are able to use the second
Edit Control to adjust the input mode of the DFX2000 between
mono (MONO) and stereo (STER). When the input mode is set
to mono, input channel 1 is used exclusively. In stereo mode,
the selected effect is applied separately to both channels. Delay
effects can have their left and right channels' properties edited
separately.
DFX2000
Default
Changed
True Voice
Note ON
Note OFF
Key's
Channel's
True #
Song Pos
Song Sel
Tune
Local ON/OFF
All notes OFF
Active Sense
Reset

Output Mode

After pushing the Setup button, users can use the third Edit Con-
trol to select the two options for the input mode. When INTL is
selected, the mixing of audio will be done internally, and thus the
Mix/Bypass Control will be active. When set to EXTN, the signal
will be 100% wet, and thus the external device will determine the
level of effect saturation by the DFX2000.
Dual Engine Configuration
Once again, by pushing the Setup button, users are able to use
the fourth Edit Control to decide the structure of the effect combi-
nations (presets 53 through 101). You can choose either serial 1
(SER1), serial 2 (SER2) and parallel (PARA).
Transmitted
OFF, 1 - 16
OFF, 1 - 16
N/A
N/A
N/A
N/A
N/A
N/A
N/A
0, 102 - 116
Yes (0 - 99)
1 - 100
YES
N/A
N/A
N/A
N/A
N/A
N/A
N/A
Recognized
OFF, 1 - 16
OFF, 1 - 16
N/A
N/A
N/A
N/A
N/A
N/A
N/A
0, 102 - 116
Yes (0 - 99)
1 - 100
YES
N/A
N/A
N/A
N/A
N/A
N/A
N/A
5