Remote Controller - Mesko MS 7854 Manual De Uso

After setting temperature under Cooling mode "K", if you select again cooling mode "K" or Fan mode "M", then LED display indicates
the default target temperature 25°C.
4. Adjust fan speed
Press the button "B" to select a desired fan speed shows by sequence:
Low speed "F" -> High speed G
5. Power
When you press the "A" button again, the device will sound "di" and stop working.
6. Press this button "N" to set a timer.
Modes working principles:
Dehumidify "L" mode:
1. The fan will run at low speed, and the speed can't be adjusted.
The adjustment of temperature is no effective. The device automatically adjusts the set temperature to 2°C below the room
temperature when entering the dehumidification mode.
2.When room temperature ≤ 16℃, cannot dehumidify, the fan will run at low speed.
WARNING:
When operating the device in conditions of varying humidity, the drain plug (8) should be constantly open and ensure constant water
drainage. To comfortable water draining use the pipe included in kit.
COOL "K" mode:
1. When the room temperature is higher than set temperature on control panel, the compressor starts to run. The device cools the
room.
2. When the room temperature is lower than set temperature on control panel, the compressor stop and the fan operates at original
set speed.
Fan "M." mode.
1. The fan runs at set speed, and the compressor does not run.
2. The adjustment of temperature is no effective.
Timer operation "N":
1. Press "N" button to set Automatic Off time while the unit is running.
2. Press "N" button to set Automatic On time while the unit is ready.
3. The time can be adjusted within a range of 1 hour to 24 hours by pressing the button "D"（+）or "E"（-).
Notice:
The main control board has memory function, when the device is ready to run but in stop status, the main control board can
memorize the initialization of working mode. When you turn on the unit, it will work as the same enactment of working-mode as last
time, no need to reset the working mode again.

REMOTE CONTROLLER

1. Slide the back cover to open and take off the isolating film on the batteries.
7