Mounting Bracket; Locating Heater - SUREHEAT ReddyHeater IWH10NLTC Manual De Funcionamiento E Instalacion Del Propietario

For changing from natural gas
supply to propane supply:
1. Remove 2 screws from cover plate located
on back of heater to expose fuel selection
device (see Figure 6).
2. For propane gas, press in knob using a flat
screwdriver with a blade the thickness of
a quarter and turn knob counterclockwise
until the knob locks into the LP posi-
tion (see Figure 6). Fuel selection device
must be locked in the LP position. Do not
operate heater between locked positions.
3. Rotate and close cover over fuel selection
device and reinstall screw.
4. Remove hex plug (with wrench provided)
from propane/LP gas inlet of regulator
(see Figure 6). Install hex plug into NG
inlet of regulator. Install gas line into
propane/LP inlet of regulator. Use thread
sealant to ensure that there are no leaks.
This heater is designed to be mounted on a
wall. For convenience and efficiency, install
heater:

Mounting Bracket

The mounting bracket is located on back panel
of heater (see Figure 7). It has been taped
there for shipping. Remove mounting bracket
from back panel.
Mounting Bracket
Figure 7 - Mounting Bracket Location
Removing Front Panel of Heater
1. Remove two screws near bottom corners
of lower front panel.
2. Pull bottom of lower front panel forward,
then down (see Figure 8).
200041-01B
All manuals and user guides at all-guides.com
INSTALLATION
Gas
Connection
Fitting

LOCATING HEATER

1. Where there is easy access for operation,
2. In the coldest part of room.
FASTENING HEATER TO WALL
www.sureheat.com
NG
LP
Back of Heater
INLET GAS PRESSURE
MAX 1/2 PSIG (3.5 KPA)
LP
NG
Bottom of Heater
Figure 6 - Settings for Propane/LP Gas
Selection
inspection, and service.
Figure 8 - Removing Front Panel Of
Heater
Fuel
Selector
Knob
Hex Plug
11