SUREHEAT ReddyHeater IWH10NLTC Manual De Funcionamiento E Instalacion Del Propietario página 12

Methods For Attaching Mounting
Bracket To Wall
Use only the last hole on each end of mount-
ing bracket to attach bracket to wall. Attach
mounting bracket to a wall only in one of two
ways:
1. Attaching to wall stud: This method pro-
vides the strongest hold. Insert mounting
screws through mounting bracket and into
wall studs.
2. Attaching to wall anchor: This method
allows you to attach mounting bracket to
hollow walls (wall areas between studs)
or to solid walls (concrete or masonry).
Decide which method better suits your needs.
Either method will provide a secure hold for
the mounting bracket.
Marking Screw Locations
1. Tape mounting bracket to wall where
heater will be located. Make sure mount-
ing bracket is level.
6 3 / "
4
12
Min.
Only Insert Mounting
Screws Through Last
Hole On Each End
Floor
Model: IWH10NLTC
10 / "
5
8
17
Min.
Only Insert Mounting
Screws Through Last
Hole On Each End
Floor
Models:
IWH16NLTC
IWH26NLTC
Figure 9 - Mounting Bracket Clearances
12
All manuals and user guides at all-guides.com
INSTALLATION
clearances shown in Figure 4,
page 9. If you can, provide greater
clearances from floor and join-
ing wall.
2. Mark screw locations on wall (see Figure
3. Remove tape and mounting bracket from
Attaching Mounting Bracket To Wall
Note: Wall anchors, mounting screws, and
spacers are in hardware package. The hard-
ware package is provided with heater.
For attaching mounting bracket to wall studs:
1. Drill holes at marked locations using 9/64"
2. Place mounting bracket onto wall. Line
1
/ "
8
3. Insert mounting screws through bracket
4. Tighten screws until mounting bracket is
14 1 / "
2
Min.
For attaching mounting bracket to hollow
walls (wall areas between studs) or solid walls
(concrete or masonry):
1. Drill holes at marked locations using
2. Fold wall anchor as shown in Figure 10.
/ "
3
8
18 / "
1
2
Min.
Figure 11 - Popping Open Anchor Wings
www.sureheat.com
WARNING: Maintain minimum
9). Note: Mark only last hole on each end
of mounting bracket. Insert mounting
screws through these holes only.
wall.
Attaching to Wall Stud Method
drill bit.
up last hole on each end of bracket with
holes drilled in wall.
and into wall studs.
firmly fastened to wall studs.
Attaching to Wall Anchor Method
5/16" drill bit. For solid walls (concrete or
masonry), drill at least 1" deep.
Figure 10 - Folding Anchor
For Thin Walls
200041-01B