SUREHEAT ReddyHeater IWH10NLTC Manual De Funcionamiento E Instalacion Del Propietario página 13

3. Insert wall anchor (wings first) into hole.
Tap anchor flush to wall.
4. For thin walls (1/2" or less), insert red
key into wall anchor. Push red key to
"pop" open anchor wings (see Figure
11, page 12).
IMPORTANT: Do not hammer anchor key! For
thick walls (over 1/2" thick) or solid walls, do
not pop open wings.
5. Place mounting bracket onto wall. Line up
last hole on each end of bracket with wall
anchors.
6. Insert mounting screws through bracket
and into wall anchors.
7. Tighten screws until mounting bracket is
firmly fastened to wall.
Placing Heater On Mounting
Bracket
1. Locate two horizontal slots on back panel
of heater (see Figure 12).
2. Place heater onto mounting bracket. Slide
horizontal slots onto stand-out tabs on
mounting bracket.
Installing Bottom Mounting Bracket
1. Install bottom bracket to heater bottom
with two screws. It may be more conve-
nient to remove heater from wall bracket
to attach.
2. Place heater on wall mounting bracket.
3. Mark screw locations on wall.
Figure 13 - Installing Bottom Mounting Screws
200041-01B
All manuals and user guides at all-guides.com
INSTALLATION
4. Remove heater from mounting bracket.
5. If installing bottom mounting screws into hol-
6. Replace heater onto mounting bracket.
7. Place spacers between bottom mounting
8. Hold spacer in place with one hand. With
9. Tighten both screws until heater is firmly
Note: Do not replace front panel at this time.
Replace front panel after making gas connec-
tions and checking for leaks.
Stand-Out Tab
Front View
10,000 Btu
Heater
Side View
www.sureheat.com
low or solid wall, install wall anchors. Follow
steps 1 through 4 under Attaching To Wall
Anchor Method, page 12. If installing bottom
mounting screw into wall stud, drill holes at
marked locations using 9/64" drill bit.
holes and wall anchor or drilled hole.
other hand, insert mounting screw though
bottom mounting hole and spacer. Place
tip of screw in opening of wall anchor or
drilled hole.
secured to wall. Do not over tighten.
Horizontal Slots
Figure 12 - Mounting Heater Onto
Mounting Bracket
Front View
20,000 Btu or 30,000 Btu
Wall
Spacer
Mounting
Bracket
(attached
to wall)
13