Perating The Receiver; Lnb Setting; Positioner Setting; User Mode - Samsung DSB-A200C Instrucciones De Uso

2/27/04 3:22 PM Page 16
OPERATING THE RECEIVER
nu
g your antenna system and STB with appropriate connectors.
AC main power and switch on the receiver.
NU key to bring up the main menu.
display will show "MENU".
ng on screen display will appear:
u topics will be displayed.
menus Installation, Channel Organising and
k you need the PIN Code.
begin with the "Installation" menu,
check in the 4th menu "System Setup"
the information there is applicable for you.
help message, press the YELLOW(ALT) key.
ation
ovides settings for customizing, adding new
displaying the status of the receiver.
stallation" in the main menu mode to select the
PIN Code.
ot entered your own PIN Code then the
00 applies, which was set at the factory.
GB-16
All manuals and user guides at all-guides.com
D I G I T A L S A T E L

1.1 LNB Setting

You can select the satellite and LNB setting conditions
to execute channel search and you can alter the settings
for 22KHz tone. The parameters set in this menu are
needed for programming the channels for the "Auto scanning"
and "Manual scanning".
The necessary information can be found at your
antenna and LNB brochures, or you can ask your dealer.
Select LNB power supply "On".
Select the desired satellite name.
Select the LNB type (frequency).
Select the DiSEqC Mode
(Off, DiSEqC A, DiSEqC B, DiSEqC C, DiSEqC D, Tone Burst A, Tone Burst B)
If you are using a Positioner, select Positioner DiSEqC1.2 ("Yes" or "No")
22KHz: In case you are using a dual LNB or two antennas connected to a 22KHz tone
switch box, with the 22 KHz tone switch ("On", "Off" or "Auto") you can switch
between both LNB or antennas.
0/12V: When you use two LNBs or antennas is switched to 0/12V, select what LNB and
antenna are used enable or disable. 0/12V terminal is located on the rear of STB.

1.2 Positioner Setting

If you have a DiSEqC 1.2 motorized system
which is fully compatible with DiSEqC1.2, then you can
take advantage of the DiSEqC 1.2 functions available.
Select Satellite.
Select any transponder from above satellites and
check out the Frequency, Symbol Rate, FEC and Polarity.
In case problems arise, ask your dealer.
Sometimes this transponder may not exist due to broadcasting.
It is better to select main transponder among them for the
desired satellite.
Select from Menu Mode:
"User" mode : Enables control of basic positioner function
recommended for beginners. General user uses "User" mode.
"Installer" mode : This is used to search for the position of a satellite manually.
L I T E R E C E I V E R
OPERATING THE RECEIVER
GB-17