Accessories - Bosch 4310 Instrucciones De Funcionamiento Y Seguridad

BM 2610012089 03-10 E:BM 2610012089 03-10 E 3/30/10 7:42 AM Page 40
pROBlEM
Blade does not completely cut
workpiece.
Head assembly does not slide
freely when attempting a slide
cut.
Head assembly slides forward
and back when making a chop
cut.
Bevel setting does not hold
position.
DAf220K Miterfinder™ Digital Angle
finder/Compound Cut
Calculator/protractor/level
Gives you the information needed to position
cuts so that they fit together precisely even if the
room is out of square.
MS1226 Replacement (Vertical) Quick Clamp
MS1228 Crown Molding Support Stop (2)
Accurately positions and supports crown molding
when angled against the fence.
Troubleshooting
Troubleshooting Guide - General
CAUSE
1. Depth stop screw adjusted
for groove cutting.
1. Slide rail lock knob tight-
ened.
2. Slide rail lock knob not tight-
ened.
1. Bevel lock lever assembly
needs to be tightened.

Accessories

-40-
CORRECTIVE ACTION
- See Depth Stop Adjustment
in the Adjustment section.
- Loosen slide rail lock knob.
- Push head assembly com-
pletely against stop. Tighten
slide rail lock knob.
- Tighten bevel lock lever as
shown on page 15.
MS1229 Extra-long Base Rod Kit
Consists of replacement steel rods that extend
the total width of base to 50-1/2"
MS1230 length Stop Kit.
MS1231 Replacement Kerf Inserts
MS1232 Replacement Dust Bag
T3B TracRac™ portable Stand with Wheels
T4B Gravity-Rise Wheeled Miter Saw Stand
lS010 Miter Saw laser Washer Guide