Assembly; Operation - Brill Basic 34E Instrucciones De Montaje

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 22

Assembly

ASSEMBLY
Scope of supply
1x operating instructions
1x assembly instructions
1x upper bar
1x lower bar
1x grass catcher, upper part
1x grass catcher, lower part
1x baffle
2x front wheel / wheel cap Ø 150 or 165
2x rear wheel / wheel cap Ø 165 or 200
1x bag of screws
1x cable holder
1x cable strain relief
Assembly of baffle (1)
1
Insert the bearing rod of the baffle.
2
Pull left-hand / right-hand springs forward un-
til they engage
3
Secure the baffl e holder with a Ø 4x14 screw
Assembly of the bars
Assembly of lower bar in housing (2)
Insert lower bar into the recesses as far as
the stop and secure on each side with a Ø
4.8x13 screw.
Assembly of upper bar on lower bar (3)
Fasten upper bar to lower bar with screw and
wing nut.
Assembly of bearing components on upper
bar (4)
1
Push on bearing rod holders on both sides.
2
Push on cable strain relief and insert bearing
rod.
3
Push on cable fixing clamp.
470711_d
Assembly of adjusting button and wheels (5)
1
Push on wheels with washers and spring lock
washers.
2
Push on wheel caps.
3
Push adjusting button onto the central cutting
height adjustment unit.
Assembly of grass catcher
Assembly of grass catcher parts (6)
Push the upper part onto the pins of the lower
part of the grass catcher.
Securing the grass catcher parts (7)
Close both parts of the grass catcher together
and secure with 2 Ø 3.5x14 screws.
Removing the mulching kit (8)
1
Lift the baff le
2
pull out the mulching kit.
3
Store the mulching kit for future use.
Attaching the grass catcher (9)
1
Lift the baff le.
2
Insert the lug of the grass catcher into the
mulching kit holder.
3
Lift the grass catcher and attach it in place.
4
Press the baffle.

OPERATION

CAUTION!
It is recommended to feed the machine
via a device of differential residual cur-
rent device (DDR), the switching current
must be less than or equal to 30mA.
Adjusting the cutting height (10)
Adjust the cutting height by means of the cen-
tral adjustment unit.
Adjustment instructions (11)
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Basic 40 e

Tabla de contenido